TECHNICAL SPECIFICATION FOR MEDICAL WASTE INCINERATOR For incineration, general and pathological

Application For incineration, general and pathological
Capacity   50 C 60 kg/h burn rate
Type Two  combustion chambers type; primary  and Secondary, controlled/forced combustion air type with a flue gas emission scrubbing unit
Operating time                Minimum 8 hours daily
Operating temperature     From 850 0C to 1200 0C, Automatic controlled
Residual Ash                    5 to 10%
Construction Constructed from heavy duty mild or aluminized  steel Or
equal and approved equivalent
Insulation material            Refractory material lining similar or equal to calcium 
Silicate and hot face combination of heavy duty brickwork
Internal Construction        Fixed hearth type complete with gratings, concave bottom
and charging door, lined with refractory material
Charging Door                   Suitable for manual loading of wastes and with smooth 
Dear seal equivalent of Ceramic seals with hinges.
Door Lock                          Automatic, Electric type
Ash removal door    Provided, for removing resultant bottom ash leftovers                              from the Primary chamber
Gratings   Provided
Loading Manual loading of waste
Primary Burner                        Fully automatic, with fuel, temperature and speed controls with ignition system, flame detector, Air 
fan complete with safety features, flame failure,  Diesel fired fuel injector type and Flange mounted                                          
                                                          
Blower Provided. For supplying excess combustion air through the distribution system with speed control system
Temperature Minimum exit 850 0C
Observation port To be provided with protective glass type
Construction   Constructed from heavy duty mild or aluminized steel or equal and approved equivalent
Insulation Refractory material lining
Combustion Temperatures        Above 850 0C, controlled electronically
Gas residue or retention Time       > 2 second at minimum 850 0C
Secondary Burner                    Provided, Diesel fired, fully automatic, with fuel, temperature and speed controls, With ignition 
system,                                                                  Flame detector, Air fan, Complete with safety features, flame failure 
Diesel fired fuel injector type.                                                                  Flange mounted
Ejector Provided, Venturi type, for cooling the flue gases
Combustion Air Fan Provided for supplying combustion and creating a negative drift and turbulences
Temperature Maximum  1600 0C
Construction   Constructed from heavy duty mild or aluminized steel  or equal and approved equivalent                                         
                        Refractory material lining

Length 10 m above ground
Bore about 350mm diameter
Discharge temperatures          About 850 0C
Emissions   To comply with standards in section 9 of third schedule of the waste management regulations, 2006.
Fully automatic with microprocessor based control                                                                      unit (PLC) automating 
all operations of the                                                                      incinerator. Capable of monitoring all incinerator 
parameters With large LCD or similar for display of all progress
Parameters  i.e. temperature of primary and secondary chambers, turbulence and time
With status lamp
With user of defined and differed programmed operating cycles for different type of loads/conditions
With safety interlocks, display of errors and visible and audio alarms.
System for continuous  emission monitoring
Supply and install isolator switch 240V, 100A for the                                                                    incinerator unit, 
including all necessary cables 10m
Supply and install distribution board. 100 A, complete with MCBs suitable for the rating of the incinerator unit and associated equipment.  
Wiring   to be done according IEE regulations.
Make provisions for wiring the isolator switch, Distribution Board control unit to Incinerator and all associated equipment inside to 
incinerator room.                                                                       Working length 20m.  Wiring to be done using PVC 
Sheath cable on steel conduits and trucking and in accordance with IEE regulations